The Wave-Length combines a thin, piezo under-saddle transducer with an 18v, low-noise, high input impedance preamp, to create a system with twice the dynamic range of typical 9v systems.
By buying this product you can collect up to 15
loyalty points.
Your cart will total 15
points that can be converted into a voucher of
$3.00.
D-Tar Wave Length Acoustic Guitar Pickup
The Wave-Length combines a thin, piezo under-saddle transducer with an 18v, low-noise, high input impedance preamp, to create a system with twice the dynamic range of typical 9v systems. The 18v preamp is powered by two “AA” batteries. With 18 volts, your signal has more headroom, so hard strumming won’t distort as easily. The preamp has an input for a second source, like a magnetic pickup or a soundboard transducer.
Two adjustable trim pots, one low frequency shelving and one high frequency shelving, allow you to fine tune and “set and forget” the bass and treble frequencies to optimize the Wave-Length for your instrument’s size and shape; enabling you transparently amplify the natural timbre of your acoustic guitar with minimal coloration. Includes 1/4 ” jack (jack 6,35) and detailed installation instructions.
Feature Benefit Unitary full length pickup Accommodates virtually all 6-string spacings and gets a more even response from the guitar’s top. Thin cable design Easy to install in guitars with either 1/8” or 3/32” saddles, often with no modification to the saddle slot. High Headroom Allows for twice the dynamic range of a 9-volt system. This means you can strum extra hard without piezo “quackiness.” Uses two “AA” batteries “AA” batteries weigh less and result in lower user cost than 9-volts. Dual Source Capability Allows the user to combine the Wave-Length with a magnetic pickup or soundboard transducer for greater complexity of signal. Adjustable Bass and Treble Trim Controls Simulates the air resonance of a variety of acoustic guitar bodies for natural sound.
Also Available with optional volume and tone Module.
The Wave-Length volume and tone module's controls are located in the soundhole for easy access. With all the controls at one’s fingertips, and the preamp itself residing at the endpin, there’s no loss of tone or dampening of vibrations due to batteries and electronics being attached to a side-mounted pre-amp assembly.
No customer comments for the moment.
Only registered users can post a new comment.
The D-TAR Multi-Source comes in two...
This model has a beautiful abalone...
